Profile Manhole Gaskets
The Profile Advantage
Easier Installation
- Less homing force required due to the unique wedge shaped design
- Self centering during joining allows for easier alignment
- Swayback compression relief prevents joint "push back" effect
- Easier to lubricate, install and equalize
- Less likely to roll, pinch or break bells
Superior Design and Performance
- More gasket surface contact area against joint surfaces
- Excellent sealing capabilities for single offset pipe
- Engineered to allow for greater joint tolerance variations
- Single step joints are easier and less expensive to produce than confined O-Ring joint
| 210-4G | PS-23 / RMS-23 |
|---|
 |
 |
| .422" – .450" TAS | .500" TAS |
These profile gaskets meet or exceed ASTM C-443 specifications
Gasket Placement Guide
Installation Is as Easy as 1-2-3
- Make sure gaskets and manhole joints are clean and free of dirt. Check for proper bedding and on-line pipe.
- Place gasket evenly around the spigot end and equalize the stretch. Apply an even amount of lubricant to the bell end and to the gasket face only.
- Push manhole section carefully together to couple. That's it!
