Profile Gaskets

The Profile Advantage

Easier Installation

Less homing force required due to the unique wedge shaped design
Self centering during joining allows for easier alignment
Swayback compression relief prevents joint "push back" effect
Easier to lubricate, install and equalize
Less likely to roll, pinch or break bells

Superior Design and Performance

More gasket surface contact area against joint surfaces
Excellent sealing capabilities for single offset pipe
Engineered to allow for greater joint tolerance variations
Single step joints are easier and less expensive to produce than confined O-Ring joint

155-4G	2100M-4F	PS-23 / RMS-23	288-4G

.326" TAS	.422" – .450" TAS	.500" TAS	.500" TAS

All these profile gaskets meet or exceed ASTM C-443 specifications

Place the gasket into the indentation of the spigot end of the pipe.

Gasket Placement Guide

Installation Is as Easy as 1-2-3

Make sure gaskets and pipe joints are clean and free of dirt. Check for proper bedding and on-line pipe.
Simply place gasket evenly around the spigot end. Apply an even amount of lubricant to the bell and face of the gasket.
Push pipe carefully together to couple. That's it!